Stripper™ Blades

stripper
replacement blades

A good fletching stripper tool can save a lot of work when preparing arrow shafts. However, to cut cleanly and efficiently, you will occasionally need new fletching stripper blades. These tempered blades fit the Stripper™ and Pro-Stripper™– and keep them cutting cleanly and at peak efficiency. Our Strippers are especially respected for their hardened blades and ergonomics. It is crucial to keep your Stripper tool blades at their best and make every job one stroke and done. When used correctly, it makes quick work of even tightly bonded fletching without damaging the shaft. 3 double-ended curved fletching stripper blades per pack.

bonding
shaft and vane preparation

Many shaft and vane manufacturers recommend prepping the shaft internally for inserts and along the outside of the vane mating surfaces by lightly sanding or scuffing them and then cleaning them properly. We recommend that you follow their instructions. As for bonding, NPV is an excellent cement. Arrow manufacturers use it because it suits many insert, fletching, and shaft materials. This video shows proper arrow preparation for NPV cement.

prep
tips and techniques

Using our Strippers to remove fletching is one of the most efficient, clean, and safe ways. Here are the best techniques to help you get the most from your tool.

• Working on a solid, flat workbench gives you better control.
• Wear safety glasses since stripping can sometimes fling glue or fragments.
• To safely secure carbon or aluminum arrows and prevent damage, clamp the arrow in a simple arrow jig or a soft-jaw vice, like the ones used to hold the shank of golf clubs.

• Start behind the vane, pushing forward in a smooth, even motion with moderate pressure—let the tool do the work.

After the vane is off:

• Go back with lighter strokes to remove glue remnants while rotating the arrow slightly
• Don’t overwork the arrow’s surface. One or two clean passes per vane is usually enough.
• Wipe the shaft with isopropyl alcohol using a lint-free cloth to clean the residue.
• Inspect for damage and look for cuts or gouges, especially with carbon shafts.
• Lightly sand if needed with ultra fine (600 grit) sandpaper if glue residue remains—just enough to dull the surface.

• .Don’t overwork the arrow’s surface. One or two clean passes per vane is usually sufficient.

Pro Tips:

• Don’t use heat or solvents before stripping—these can weaken carbon shafts or melt glue into the surface.
• Check and replace dull blades since a dull blade increases the risk of damaging the shaft.